I've saw a cisco switch/router that connected with connected ethernet cable to the console port. I was curious how the remote site console in with the ethernet cable from 100km place instead of using cisco rollover console cable.
I am not sure about your question. But Cisco has various products for out-of-band management. For instance the Cisco AS2509 and AS2511 Access Servers. They connect up to 16 routers with either an octal cable or roll-over cables.
The octal cable has a scsci connector on the far end and breaks out into either 8 or 16 RJ-45 cables. These are connected to the console port of the router.
However the Cisco AS2500 series are widely used, they're end-of-line for quite some time. Replacement product is NM-16A/S or NM-32A/S module for modular access routers such as 2600 and 2800 series routers.
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 126.96.36.199 as the RP for these groups:188.8.131.52/32184.108.40.206/32220.127.116.11/2418.104.22.168/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...
Meet the Authors Event - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT ...