cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
134
Views
0
Helpful
1
Replies
Beginner

Restrict throughput

Is there anyway to limit or restrict the bandwidth usage on a single port on a 1924 Catalyst switch?

1 REPLY 1
Highlighted
Cisco Employee

Re: Restrict throughput

Doesn't look to be a way to restrict bandwidth per port on the 1924. You can restrict the amount of broadcasts seen using the 'storm-control' global command.

You can also check the port statistics using the 'show usage utilization' command. And also the 'show interface ether x/y' to see how much a port is being used.

But it does appear that you have full access to the port speed setting. Either 10 or 100Mbps (for the uplink ports).

CreatePlease to create content
Content for Community-Ad