Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
287
Views
0
Helpful
3
Replies

RIP Interface on OSPF router

bth_dad
Level 1
Level 1

‎04-11-2003 10:10 AM - edited ‎03-02-2019 06:36 AM

I have run into the misfortune of needing to participate in RIP v1 routing on a single interface off of a 4500 switch. The switch/network currently is running OSPF as the routing protocol and all I really neeed is a single interface to send and receive RIP routing updates. After I have turned RIP on the switch, what is the best way to assure only that one interface is sending and/or receiving updates?

Thanks for any help.

Todd

Labels:
0 Helpful
3 Replies 3

deilert
Level 6
Level 6

‎04-11-2003 10:38 AM

you can passive out all the interfaces

0 Helpful

bth_dad
Level 1
Level 1
In response to deilert

‎04-11-2003 11:09 AM

Yes, I am aware of that. What I really want to avoid is having to passive 60-some interfaces just for one to work. I was hoping there would be a way to apply to just one interface.

0 Helpful

deilert
Level 6
Level 6
In response to bth_dad

‎04-11-2003 11:29 AM

try to use

router rip

passive-interface default

no passive-interface int serial something

0 Helpful
Customers Also Viewed These Support Documents