Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
250
Views
0
Helpful
1
Replies

rommon parameter erase

rburkhard
Level 1
Level 1

‎04-18-2005 11:32 PM - edited ‎03-02-2019 10:29 PM

Hello,

During upgrade of a Sup720, ios 12.2(18)SXD3 switch booted in rommon.

I have set some rommon parameter,eg. MANUAL_BOOT=NO,

But if I made an error during type , eg. Manual_boot=NO, I could not eliminate this wrong line. Each set command shows this wrong line.

Does anyone has same experience?

Thanks in advance

Ruedi

Labels:
0 Helpful
1 Reply 1

j-block
Level 4
Level 4

‎04-25-2005 05:57 AM

I didn't faced any problem as you said, I attached the link that will you more on upgrading the SUP 720.

http://www.cisco.com/en/US/products/hw/switches/ps700/prod_release_note09186a008007f706.html

0 Helpful
Customers Also Viewed These Support Documents