cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1444
Views
0
Helpful
3
Replies

Route-map

Hello Experts,

 

I could able to see many route-map when I give command sh route-map in CLI, but when I tried to see the running config I could able to see only 2 route-map that are bind to the BGP neighbor. 

 

Is there any command to check where the route-map is bind with?

 

Thanks

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

Can you post the configuration here to confirm what route-map configured?

 

you can check

 

show run | in route-map

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

If you can post the configuration that will be great.

 

Meanwhile can you double check configuration was properly saved and Bind to BGP.

 

Please rate all helpful posts

Route maps can be used for many purposes beyond their use in BGP. Among their many uses would to to control redistribution in a routing protocol, to control address translation, to control Policy Based Routing. I do not know of any command that would identify how each route map is being used. The only way I know of to do this is to manually examine the configuration, finding each route map, noting the name of the route map and then looking in the config for where that name is used.

 

HTH

 

Rick

HTH

Rick
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco