08-29-2004 11:15 AM - edited 03-02-2019 06:05 PM
Hi all ,
i tried to configure router 1601. i connect to console and change all setting .. when router boot on the last step give me following error :
Tranceiver Problem??
Can any advice me ??
08-29-2004 11:54 AM
Hello,
does the error message look like this ?
1d12h: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
This is normal and just means that there is nothing connected to your Ethernet port.
Regards,
Georg
08-29-2004 12:46 PM
:) good, but why i can't access to privlege mode.? and if this msg apear on screen and i press enter it's back again ?? am sorry for this question ..
08-29-2004 01:21 PM
Hello,
regardless of the message, you cannot type ´enable´ at the ´Router>´ prompt ? Can you post what you see on your screen ?
Regards,
Georg
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: