08-27-2004 04:49 AM - edited 03-02-2019 06:04 PM
Hi!
I'm trying snif traffic on port 12 on my C2950 by setting up RSPAN and and send it to port 48 on my C3550. Those two switches are connected via a dot1q trunk.
And here are the configs:
On the 2950:
monitor session 1 source interface fastEthernet 0/12 both
monitor session 1 destination remote vlan 310 reflector-port fastEthernet 0/23
On the 3550:
monitor session 1 source remote vlan 310
monitor session 1 destination interface fastEthernet 0/48
VLAN 310 is created on a VTP server and exists in both switches.
But (as I'm sure you have guessed by now :) this does not work.
The sniffers i connect to port 48 on the C3550 does not recieve any traffic at all.
So.. any ideas? This should be possible right?
I got the setup from http://www.cisco.com/en/US/customer/products/hw/switches/ps628/products_configuration_guide_chapter09186a00800c6f14.html
the document for the C3550 i pretty much the same, so I can't see any reason for this to work.
Thanks,
Øystein Gåsdal
Norway
08-27-2004 05:13 AM
Hi,
Did you create VLAN 310 as an rspan VLAN?
vlan 310
remote-span
end
Also, i'd double check whether your dot1.q trunk is trunking 310
HTH
Paddy
08-27-2004 05:20 AM
No, actually I did not create it as a rspan vlan?
So this must be done in the VTP server then?
Thank you, I'll try this right away :)
08-27-2004 05:31 AM
Hmm, I just realized that the VTP server is on a C3508G, and that command does not exist there.
So what are my options?
make the C2950 and the C3550 vtp transparent and create the vlan 310 manually... But then I get no more VTP updates from the server.. or?
Or I could move the VTP server to a device that supports this command, like the mentioned C3550.. that is probably the most permanent solution.
anything easier I haven't thougth of? :)
Thanks,
Øystein Gåsdal
Norway
08-28-2004 04:36 AM
Hi,
Is the C3508G still available, perhaps you could check for a newer version of code with the rspan VLAN feature and upgrade the firmware.
This way you don't have to change your VTP structure
Thanks
Paddy
08-30-2004 12:21 AM
As far as I can see the C3508G is still available, but has no software that support RSPAN.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide