cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
144
Views
0
Helpful
1
Replies
b_ferguson
Beginner

setting up 2 vlans for 2 pixs.

I have a situation that I was trying to seek some assistance on. At this site, there are 2 Internet connections, 1 T1 and 1 Cable. Right now everything is going out the T1. They would like to add the cable ISP and a PIX 501 for guests and have all the Access Points using the Cable ISP and keep everything internal using the T1 like they are now. The current setup goes like this. T1 -> PIX 515 -> Cisco 4000 series router -> 2950. Would like the add the Cable -> PIX 501 -> 2950 -> AP. I know that I need to configure a VLAN for the wireless on the 2950s, but how would I configure a default route since the default route is being used already for the the other VLAN? I think that I am making this much more difficult than it really is.

1 REPLY 1
Edison Ortiz
Hall of Fame Mentor

Each VLAN will have a different default route. Configure the DHCP server on the wireless VLAN to have the PIX 501 connected to the Cable broadband connection as the default gateway.