11-26-2014 12:03 AM - edited 03-03-2019 07:40 AM
Hi,
#sho ver
produces this error, before outputting the rest of the expected results of a sho ver:
Ver read taking too long. Aborting
proton_firmware_version_read failed asic 3
then the rest is shown:
Cisco Nexus Operating System (NX-OS) Software........
......
What is the issue? It's happening on a pair of N5K's, so it's not likely a single hardware failure issue, but a config issue....
NX-OS system: version 6.0(2)N2(2)
07-12-2015 08:34 PM
Hi Jason,
Have you managed to find the cause for this? I am encountering similar issues as well.
Please advise.
Thanks and Regards,
Kanes.R
07-12-2015 08:52 PM
Have you considered upgrading the IOS?
07-12-2015 09:04 PM
Hi Leo,
IOS upgrade is not an option at this point of time, i would need some concrete evidence that this is an IOS related fault.
Thanks and Regards,
Kanes.R
02-12-2016 09:45 AM
Same here, on a 5596UP on 5.2(1)N1(6). Plus i'm affected by CSCun66310 so definitely can't upgrade nor even reboot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide