11-26-2014 12:03 AM - edited 03-03-2019 07:40 AM
Hi,
#sho ver
produces this error, before outputting the rest of the expected results of a sho ver:
Ver read taking too long. Aborting
proton_firmware_version_read failed asic 3
then the rest is shown:
Cisco Nexus Operating System (NX-OS) Software........
......
What is the issue? It's happening on a pair of N5K's, so it's not likely a single hardware failure issue, but a config issue....
NX-OS system: version 6.0(2)N2(2)
07-12-2015 08:34 PM
Hi Jason,
Have you managed to find the cause for this? I am encountering similar issues as well.
Please advise.
Thanks and Regards,
Kanes.R
07-12-2015 08:52 PM
Have you considered upgrading the IOS?
07-12-2015 09:04 PM
Hi Leo,
IOS upgrade is not an option at this point of time, i would need some concrete evidence that this is an IOS related fault.
Thanks and Regards,
Kanes.R
02-12-2016 09:45 AM
Same here, on a 5596UP on 5.2(1)N1(6). Plus i'm affected by CSCun66310 so definitely can't upgrade nor even reboot.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: