07-10-2012 08:32 AM - edited 03-03-2019 06:40 AM
Hello all ~
I am study the ccnp but I don't understand this command "show ip router summary"
who can explain ?
how can I compare this command and config ?
R2#sh ip route summary
IP routing table name is Default-IP-Routing-Table(0)
Route Source Networks Subnets Overhead Memory (bytes)
connected 0 4 256 608
static 0 0 0 0
internal 2 2344
Total 2 4 256 2952
R2#
interface Loopback1
ip address 192.168.200.1 255.255.255.252
!
interface Loopback5
ip address 192.168.200.5 255.255.255.252
!
interface Loopback9
ip address 192.168.200.9 255.255.255.252
!
interface FastEthernet0/0
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0
ip address 172.16.1.1 255.255.255.0
Solved! Go to Solution.
07-10-2012 01:40 PM
Hi Cash,
show ip route summary
R2#sh ip route summary
IP routing table name is Default-IP-Routing-Table(0)
Route Source Networks Subnets Overhead Memory (bytes)
connected 0 4 256 608
static 0 0 0 0
internal 2 2344
Total 2 4 256 2952
Please rate if it helps.
07-10-2012 01:40 PM
Hi Cash,
show ip route summary
R2#sh ip route summary
IP routing table name is Default-IP-Routing-Table(0)
Route Source Networks Subnets Overhead Memory (bytes)
connected 0 4 256 608
static 0 0 0 0
internal 2 2344
Total 2 4 256 2952
Please rate if it helps.
07-11-2012 06:26 AM
Hello ,
As stated by the above post ip route summary gives you the current state of the routing table, like where excatly the routes originated and how many prefix are been used by routig protocol with number of bytes used by routes.
This command is mainly used to check the state of the routing table.
Hope to help !!
Ganesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: