cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Slip secs on t1 PRI increasing

dathaide
Beginner
Beginner

i have a PRI connected to a PBX and noticed the slip secs increasing i have already tried changing the cable length and the clock source as stated in the documnet below and found no resolution. Any suggestions

thanks

http://www.cisco.com/en/US/partner/tech/tk713/tk628/technologies_tech_note09186a00801095a3.shtml

1 REPLY 1

fmachoka
Beginner
Beginner

You will need the assistance of your provider to determine why the line clock is not synchronizing. Verify with your provider if the clock configuration under the controller matches what is provisioned on the line.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: