06-16-2004 11:12 PM - edited 03-02-2019 04:26 PM
WHAT configuration is needed for the switches (eg 3550) such that it will send activities like shutdown, rebooted, port down etc to the cisco works.
I've had snmp enabled on the switches already and was able to discover the switches but cant received such activities.
thx a lot
06-17-2004 06:39 AM
First tell it what your CW2K IP address is:
snmp-server host w.x.y.z somestring
Then pick the snmp traps you wish to receive:
snmp-server enable traps ?
06-17-2004 07:52 AM
Which application in CiscoWorks do you want to see the messages in? DFM uses SNMP so you will need to specify the server as a trap-receiver (snmp-server host [CW2K IP] [some SNMP string]).
If you want to get the messages via RME's Syslog, you need to specify:
logging [level of Syslog messages to receive]
logging [CW2K IP]
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide