Hi,
I need to do the following...
-to be able to receive a full e1 on a card on a 3600.
-separate different slots into different subinterfaces
-then, grab the slots asigned to one of the subinterfaces
and 'hairpin' them to a serial interface (v.35).
is there such a funcionality on a cisco?
another way to look at this would be:
-the e1 comes into the router and it's dechannelized
-some slots are assigned to a subinterface for ip usage
-other slots are patched (untouched) through to a serial interface
(videoconference traffic)
if thes wasn't clear enough, please contact me.
regards,
carlos silva.