07-08-2003 02:06 PM - edited 03-02-2019 08:42 AM
07-08-2003 04:46 PM
It should with the full-duplex interface command.
I'm running 12.1(19)
Show inter e0/0 will not show duplex status
show controllers ethe 0/0 will show duplex setting
07-11-2003 06:03 AM
Yes. The concept of half vs. full duplex only applies to bus architectures (eg Ethernet with multiple machines in a collision domain). E1s, T1s, E3/D3/OC-x,etc are not busses, and so there is no chance of multiple machines transmitting and causing a collision. This means that the transmitter does not need to wait and monitor to ensure that it is not causing a collision, and so can transmit while receiving.
Warren.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide