the customer has 3750 standart with a single active fisico port which belongs to vlan 1, but the traffic of the
fisico port and of they vlan it are different
why ?
FastEthernet1/0/9 is up, line protocol is up (connected)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 34000 bits/sec, 22 packets/sec
30 second output rate 189000 bits/sec, 27 packets/sec
22713516 packets input, 3182556464 bytes, 0 no buffer
sho int vlan 1
Vlan1 is up, line protocol is up
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:18:22, output 00:00:15, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 6000 bits/sec, 4 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
15112592 packets input, 2283856970 bytes, 0 no buffer
fisico 34000bits/sec vlan 6000 bits/sec
help ?
