11-03-2021 08:55 AM - edited 11-04-2021 05:42 AM
11-03-2021 09:13 AM - edited 11-03-2021 09:19 AM
Sw(config)# interface interface_id
Sw(config-if)# switchport trunk encapsulation dot1q
Sw(config-if)# switchport mode trunk
I think in this case it is better to configure port 1-2 on each switch in same port-channel
11-03-2021 09:51 AM
I figured switchport mode trunk would be there somewhere. Do you think any channel group commands should be added to it? Or Switchport mode dynamic desirable?
11-03-2021 10:29 AM
Do you think any channel group commands should be added to it?
In your topology if you do not use channel-group then one of the ports will be blocked by STP.
Switchport mode dynamic desirable?
Here is a excellent explanation about it:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: