cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
325
Views
3
Helpful
2
Replies

TUNNEL for Standard Sync Serial Data Needed

rick.payne
Level 1
Level 1

Need help or a good reference point to connect a 530 serial port on one Cisco to another serial port on a different cisco and have them linked together transparently via IP. I am gussing I need to build a tunnel between the two router, but after that I am unsure of the exact configurations needed. The end devices will be DTE Muxes with a 530 interface. I will use the Timming from the cisco's to provide timing and clocking to the muxes.

Thank you,

Rick

2 Replies 2

samsam_wang
Level 1
Level 1

R1 s0-------s0 R2

R1 s0 192.168.1.1/24

R2 s0 192.168.1.2/24

R1

int tunnel 0

ip addr 192.168.1.3 255.255.255.0

tunn source se 0

tunn desti 192.168.1.2

R2 same as above

Will I have to use DCE cables from the router to the muxes and config the Bandwidth and such on the router interface to provide the needed timing and clock or will this act as a transparent tunnel between the 2 serial ports.

Thank you again,

Rick

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: