06-24-2004 04:25 AM - edited 03-02-2019 04:36 PM
It seems that neighter "set ip default" or "set ip next-hop" is supported on my Catalyst 3550 sw/v 12.1(12c)EA1. Is this correct?
06-24-2004 04:55 AM
Hello,
AFAIK, before you can enable policy routing, you must configure one of these commands in the global configuration mode, and then the configuration must be written and the switch reloaded:
sdm prefer extended-match
sdm prefer access extended-match
sdm prefer routing extended-match
HTH,
Georg
06-24-2004 06:49 AM
Hi,
read http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12112cea/3550scg/swuncli.htm#xtocid24
and comapare with latest IOS
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12120ea2/3550scg/swuncli.htm#wp1014499
Regards,
Milan
06-28-2004 03:32 AM
Milan,
so entering the "sdm prefer" -command wont help since the "set ip default" and "set ip next-hop" isnt supported?
What do they mean with this page:
http://www.cisco.com/en/US/tech/tk364/tk871/technologies_configuration_example09186a00802135d3.shtml
where the commands are included in rhe example for C3550?
06-28-2004 05:23 PM
Just to answer your question about the page you posted, the Cat3550 IOS version in that
example is 12.1(19)EA1a, which already supports the command "set ip next-hop".
It is documented here:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12119ea1/3550scg/swuncli.htm#1014499
The command "set ip default next-hop" is still unsupported up to the latest IOS version.
As Milan had mentioned, please compare the old IOS releases with the new ones to check any new features or solved caveats. I think it's time to upgrade your IOS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: