Hi all,
yesterday I performed an update from a 3.x version to the 16.3.8 version on a stack of C3850 switches.
I included the "auto-rollback" command with the "software install" command in order to have a rollback scenario, just in case.
The documentation says that once the update has completed you have to enter the "software committ" command in order to cancel the auto-rollback. But with the 16.3.8 version there is no "software" command anymore.
Actually nothing happend after the specified amount of time.
I just cleaned up the flash with the "request platform software package clean switch" command.
Maybe that did the trick as that command also deleted the old "packages.conf" file.
Has anyone ran into the same problem?
BR
