10-14-2003 11:19 PM - edited 03-02-2019 11:01 AM
Hi
Is it possible for me to upgrade from CatOS to IOS on my C4306? Is it just a command to change from CatOS to IOS or do I have to change firmware (how do I do this on CatOS?)?
xxx (enable) sh ver
WS-C4003 Software, Version NmpSW: 6.3(2)
Copyright (c) 1995-2001 by Cisco Systems, Inc.
NMP S/W compiled on Oct 5 2001, 01:47:11
GSP S/W compiled on Oct 04 2001, 21:55:28
System Bootstrap Version: 5.4(1)
Hardware Version: 2.2 Model: WS-C4003 Serial #: JAE0535039T
Mod Port Model Serial # Versions
--- ---- ---------- -------------------- ---------------------------------
1 0 WS-X4012 JAE0535039T Hw : 2.2
Gsp: 6.3(2.0)
Nmp: 6.3(2)
2 34 WS-X4232-GB-RJ JAE05380346 Hw : 2.3
3 6 WS-X4306 JAE053700S6 Hw : 2.0
DRAM FLASH NVRAM
Module Total Used Free Total Used Free Total Used Free
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
1 65536K 31294K 34242K 12288K 8768K 3520K 480K 187K 293K
Uptime is 21 days, 10 hours, 12 minutes
xxx (enable)
Thanks in advance!
Regards Jimmy
10-15-2003 01:50 AM
Hi,
WS-X4012 Catalyst 4000 Supervisor I. doesn't support IOS, I'm afraid (see http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_2170.htm#16938).
Read also Questions and Answers in http://www.cisco.com/warp/public/cc/pd/si/casi/ca4000/prodlit/4kse3_qp.pdf.
Regards,
Milan
10-15-2003 11:04 AM
CAT4003 supports only Sup1. You'll need either Sup2+, Sup3 or Sup4 to run IOS and your chassis will not support these cards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: