09-29-2003 10:39 AM - edited 03-02-2019 10:39 AM
i have the following VTP Domain scenario, and i want to configure VTP Prunning for clearing some Vlans .
This configuration is in the 2 Clients.
Can configure Prunning in this 2 client???/
or i need to make this configuration in the VTP Server????
-----=====-------======--------
Server Client Client
09-29-2003 03:48 PM
You make them on the server if you are using the server,client scenario .
09-30-2003 04:34 AM
But i don't want to configure the Server.
I only want to prune a trunk link Betwen 2 Clients.
Can i make this configuration Without configure the server???
08-20-2012 06:51 AM
I will answer this for the sake of future visits on this thread:
In order to enable VTP prunning you need to enable it on only one VTP server (works for VTP v1, v2) or on EACH VTP server switch if you run VTP v3.
This is aplicable for a single VTP domain.
08-20-2012 03:46 PM
Hi,
If you don't want vlan traffic to cross between the clients you can allow the vlans on the trunk:
switchport trunk [allow/pruning] vlan xxx,xxx,xxx
Hope this helps
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide