04-04-2005 09:24 AM - edited 03-02-2019 10:21 PM
Hello
WCCP is supported on 3550 Catalyst switches with EMI. Is it supported on any 3560 or 3750 switch ? We need a L3 switch more performant than the 3550 but not as expensive as the 6500 series.
Could you help ?
Thank you in advance.
Solved! Go to Solution.
04-06-2005 10:32 PM
04-04-2005 09:31 PM
Hi,
Both 3560 and 370 supports WCCP.
Make sure WCCP is only supported with EMI image.
HTH
Regards,
Ankur
04-06-2005 09:05 AM
Hello
Thank you for your answer. However, I cannot find a single document or link on cisco.com indicating the support of WCCP on 3750 switches, not even on Software Advisor, on Feature Navigator II or on the 3750 command reference.
Could you please give me a link to this information ?
Regards.
04-06-2005 10:32 PM
04-06-2005 11:59 PM
Well done ! EMI image is needed for WCCP.
Thank you.
04-07-2005 01:44 AM
Hi,
I would double check this with Cisco before purchasing, i also read this pdf file, however when i went to configure WCCP on our existing EMI 3750 switches it was not supported:
ds-gsw-a#dir flash:
Directory of flash:/
2 -rwx 1816 Feb 15 2005 12:35:15 vlan.dat
4 -rwx 9051 Mar 07 2005 15:24:48 config.text
5 drwx 192 Mar 01 1993 00:05:04 c3750-i5-mz.121-19.EA1c
85 -rwx 47 Mar 07 2005 15:24:48 private-config.text
15998976 bytes total (8942080 bytes free)
ds-gsw-a#conf t
Enter configuration commands, one per line. End with CNTL/Z.
ds-gsw-a(config)#ip wccp ?
% Unrecognized command
There also isn't any configuration guides on configuring WCCP for the 3750 but there is for the 3550/60 so proceed with caution.
Rgds
Paddy
04-07-2005 08:42 AM
Hello
I also tried with a Catalyst 3750G-24TS-S and with these two images :
- c3750-i5-mz.122-25.SE.bin
- c3750-advipservicesk9-mz.122-25.SEA.bin
It went out that the 'ip wccp' command does not exist.
The Catalyst 3750 french datasheet also speaks about WCCP support with the EMI image.
Which software should I try ? and could you confirm WCCP support on the 3750 ?
Thank you again.
04-07-2005 10:40 AM
I'm in the same boat.
I'm using c3750-ipservices-mz.122-25.EZ.bin and the command is not available.
I'm going to open a tac case. I'll let you know what I find out.
Marco
04-07-2005 11:37 AM
Ok, here's what TAC got back to me with.
WCCP is not currently supported on the 3750 switches. TAC told me it's planned for the first half of this year and to check back in June 05. It will only be supported on the EMI code.
Marco
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: