07-08-2004 06:08 AM - edited 03-02-2019 04:56 PM
Within Wireless LAN were using ATM as transport network between 2621XM hotspot router and the SSG. In the past we used NM-4E1 on 2621XM. Due to EOS we needed to use AIM-ATM-4E1 now. The configuration of the new ATM interface card is different from NM-4E1. Where can I find information how to configure AIM-ATM-4E1 on 2621XM for ATM (PVC and IMA)?
07-11-2004 04:40 PM
This is a link to some basic ATM configuration on the 2600. Includes PVC SVC IMA etc.
07-13-2004 04:20 AM
Problem has been resolved in the mean time. Information was provided by Cisco SE to whom the info request was sent in parallel.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: