I have a pair of 3850's, between them is a 5 member Etherchannel, on each Port there is a Pair of Microwave Radios, 10 in all, that have specific IP addresses for management, in a specific in band management Vlan100, it is not native and not Vlan 1, all the radios are on the same Vlan, same IP sub-net, but of course inside the Etherchannel.
With the Etherchannel, you cannot tell which port the traffic to a particular radio will use, so the radios cannot be managed.
I am trying to use a V-ACL or P-ACL to take traffic that enters the management Vlan, with a specific IP address destination, and direct that traffic to the correct Etherchannel member port...or should I be attempting this on the Etherchannel ingress?
So, i need some assistance on the required Access List into the Management Vlan, and how to direct that matching traffic for each radio IP to the correct Etherchannel member port... I am just not finding this specific situation in documentation so far.
Thx!