01-16-2006 01:02 PM - edited 02-21-2020 12:38 AM
Hello,
I have been told I need to add some routes to the PIX to allow some IP addresses to pass traffic. When I try to add the route the PIX says "cannot add route entry" Below is a sample route I am trying to add. Can anyone tell me what might be wrong?
route BiznezzINTF 2xx.1xx.1xx.xx 255.255.255.255 10.0.10.175
This is the exact command I am trying to enter (with a real public IP address of course. I know that much!)
All repliess will be rated.
01-16-2006 01:47 PM
Are you trying to add route statements or static translation statements. A route statement tells the pix how to get to a specific network.
If you are trying to allow specific inside addresses to be allowed outside you need to use access-list and NAT statements.
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml
I've attached a few websites for each scenario to try to help you out. If you need more help please let me know.
Steve
01-16-2006 05:14 PM
"route BiznezzINTF 2xx.1xx.1xx.xx 255.255.255.255 10.0.10.175"
verify the interface name BiznezzINTF. i was thinking the the 10.0.10.175 has to be on the same range of the pix connected interface, however, it's not the case as i tested it with both v6.x and v7. so the only thing i can think of is the interface name.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: