I have two ASA 5585X-SSP20 need to Cluster config. I am little confused about ASA to Core Switch and Server Firm Switch Connectivity. In cluster mode if we config master asa two 10G port as an ether-channel then others cluster member same port config as a same ether-channel.So four port in two asa work in single ether-channel. If this right then my diagram is correct or wrong. Plz help me.
yes,technically you could run two SSP20's with all 4 10g ports in the same spanned etherchannel as a "firewall on a stick".
If you look in the cluster configuration guide you'll see that the CCL (Cluster Control Link) needs to be sized the same as the data links so if you don't add any extra modules to your SSP20 firewalls you'll end up with 1x 10g for data and 1x 10g for CCL on each physical firewall.
We currently have this setup in our environment; each SSP20 firewall is connected to a Nexus 7K switch where one 10G port is used for CCL and one 10G port is setup as a trunk for all inbound/outbound traffic to/from the firewall.
Setting up some 3rd party devices for my Fire and Rescue trucks that will VPN back to our FPR-2110. I can blatantly see what's going on with the IKEv2 platform and protocol debugs on. It's selecting the wrong dynamic map!IKEv2-PLAT-4: (32): Cry...
On January 22, 2020, the Cisco Product Security Incident Response Team (PSIRT) disclosed a vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC). The vulnerability could allow an unauthenticated, remote attac...
Meet the Authors Event - A Cybersecurity Deep Dive with Omar Santos
(Live event – Thursday, January 23rd, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event will have place on Thursday 23rd, January 2020 at 10hrs PDT
Posting this for anyone interested in using a Raspberry PI as a flow collector for Stealthwatch. We created a very lightweight version of our software. It can create flows if the eth port is attached to a SPAN or you can forward NetFlow/IPFIX ...