01-09-2023 11:52 AM
Hi.
Within a HA cluster of two ASA 5525s, when I enter either device, they copy the config to each-other to represent 1 device. I need to label g0/4 interface as 192.168.0.1 on ASA1, and the other g0/4 as 192.168.0.2 on ASA2. How do I do this? (I assume I need to access the individual OS, not the virtual singular device.)
Solved! Go to Solution.
01-09-2023 11:59 AM
@jmaxwellUSAF unfortunately I don't think that is possible, as the configuration on the control unit is replicated to all other members.
01-09-2023 11:59 AM
@jmaxwellUSAF unfortunately I don't think that is possible, as the configuration on the control unit is replicated to all other members.
01-13-2023 05:24 AM - edited 01-13-2023 05:24 AM
Are you asking about a cluster or an HA pair? For an HA pair, we can set the ip address of an interface on the standby unit using the "standby" keyword at the end of the IP address line in the cli when in interface configuration mode.
In ASDM, this is set under the Device Management, High Availability section.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: