09-16-2008 04:21 PM - edited 03-09-2019 09:29 PM
Hello, im about to upgrade one asa from 7.0 to 8.0.3 and also the ASDM from 5.7 to 6.0.3, the question is, do i need to first 7.0 to 8.0.1 next 8.0.2 next 8.0.3 and also the same to ASDM?
Or just copy from 7.0 to 8.0.3 ?
Thanks in advance.
09-17-2008 05:04 AM
7.0.x to 7.2.x
7.2.x to 8.0.x
x--> any number
Do not go directly from 7.0.x to 8.0.x.( not recommended by cisco )
Please rate if helpful.
Regards,
Sushil
09-17-2008 05:43 AM
Hi Sushi, thanks for your reply.
The upgrade was a success :).
7.0(7) to 8.0.3 and asdm-507 to asdm-603, just one small problem, because the 8.0 was not active.
"asdm image disk0:/asdm-603.bin
Device Manager image set, but not a valid image file disk0:/asdm-603.bin"
after reboot (8.0.3), ASDM run with no problems.
Thanks one more time Sushi.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: