I have a need to let Connect:Direct (C:D) file transfers through a router with the IOS firewall feature set. Has anyone had experience of doing this and did you have any problems ?
It seems that both "pdm location" and "http" commands specify IP addresses from which you can run PDM to manage the PIX. What is the difference between these 2 commands?
I am trying to install a new IDS on my network and am having trouble setting up the system variables. I can't seem to figure out the proper format for entering the IP addresses. My network has a somewhat goofy IP range set up and I would like to jus...
I update a pix535 from 6.0 to 6.1,after i finish the update os then reboot pix ,but it cann't load new os £¬why ?the message list below:Not enough supported network interface cards installed. PIX requires at least 2 supported interface cards, b...
Dear All,Until now I didn`t find any update for version 3.6.7F bug fixes on the CCO.So far Cisco had announced that recent vulnerabilities are fixed only on "version 3.6.7F".As my testing result here, VRRP+IPSec over TCP doesn`t work . From other pos...
Hell-o,Just installed a firewall between our main campus and satelite campus. Now my windows dc's cannot talk to eachother. Does anyone know what I need to do to pass windows active directory replications through?TIA,Gary
so, I have just installed VPN Client 4.0, and appears the error windows: The necessary VPN sub-system is not available.......What shall I do, or what shall I test at least? I have installed it for 3 times.I am using DSL with pppoE, the ICS is being d...
IDSMC is up to 4.0-2-S46 and the sensor is 3.0 and should be around 45. I applied the newest idsmc patch. When trying to add this sensor BACK to the mc after removing it, i get the following error:An error occurred while trying to save the signatur...
I am trying to upgrade a 4.0 Sensors signatures with CiscoWorks VMS. All of the 3.1 sensors upgrade with no problem. However, when I try to upgrade a 4.0 the ip audit log generates this error:"10.1.4.252: Error importing sensor version from the sen...
is it possible to do VOIP with VPN. I am planning to install 3002 hardware client at site and do VPN through internet backbone. I also want to connect VOIP phone to 3002 hardware client? I need to know if 3002 hardware client will support voip ? Than...
I installed SDM 1.0 on our 3620 router. When I go to access the SDM via either http or https the inital page comes up, but the pop up manager doesn't come up. I have it loaded into slot1 flash as we don't have enough room in default flash. I tried th...
Hi All,I have a primary and secondary switch set up with multiple vlans on each and trunking between them. I also have a primary local director bridging between two of the vlans on the primary switch with a failover local director doing the same on...
i upgrade os on the pix535 from 6.0.1 to 6.1.4, after reboot, why pix535 notice the message:Ignoring PCI card in slot:4; and the pix535 not to boot correctly,and notice :no enough the network interface.
