Here is my config on supervisor II on 4006 switch Console> (enable) show spanDestination : Port 4/10Admin Source : VLAN 2Oper Source : Port 2/3,2/5-6Direction : transmit/receiveIncoming Packets: enabledLearning : enabledFilter...
Hi,I am facing problem with pcanywhere connection through my PIX firewall.I have an access-list which says : access-list permit ip any anythe pcanywhere works fine with this.now In place of "permit IP any any" , i want to allow ports 5631 and 5632 ...
Hi,has someone a running configuration for the following scenario:- Cisco 826 as EZVPN Client (fixed IP Address on Ethernet 0, IP Address negotiated on dialer 1)- PIX 515 as EZVPN ServerThanks in advanceEdgar
I have several custmomers that are considering Fatpipe's Superstream and would like to sell Cisco product instead. Has anyone duplicated the functionality in Cisco gear? Basically,its aggregating bandwidth from two small Internet pipes. I.E. DSL, Ca...
I have 2 routers and 2 pix firewalls which are connected point-to-point via frame-relay..On each of this networks, reside an NT Domain configured as trusted (through trust relationship)...This will enable me to brouse the other network and vise vers...
I have site to site connection as fallows;3005_A---> internet ---->3005_B----> internet ---->3005_C --->3005_DI can connect and ping from site 3005_A to 3005_B and from 3005_B to 3005_C , but can’t connect directally from A to C or from A to DDoes I ...
Hi,I have a problem with my pix. The situation : i must nat if the packets go to my vpn.i must nat if the packets go to the web.So i must define one rules of nat for each case. But i don"t know how says that to my pix. I think used an acl (same as w...
I'm assisting a school district with some network issues. Last Friday they had an accidental power failure, upon returning everything back to an up state no one seems to be able to get through the VPN 3000. We authenticate but can not get to any de...
I have a PIX-515(This product has reached end-of-sale),not PIX-515E.It have two slots,I have installed two ethernet cards.but when I reboot the PIX,I can use 3 interfaces only,why?
Hello - My Question is at what point do we decide to look at adding another 3030 Concentrator for Redundancy and to Load balance. We have 250 sites nationwide that connect via BB using the 3002 HW client and 100+ via dial up using the software clien...
Is it true that if Primary and Secondary DNS servers are either sides of PIX and PIX is using NAT the ZONE transfer will fail if the file is too long?ThanxVikas Khanduri
Hi,I need to open a session X between an inside interfaceand the dmz. I put a acl by opening the port xdmcp inside towards dmz but how to make for dmz towards inside and ports 6000 and 6063?thanks
