Other Security Subjects

Dear all,When the sniffing interface is connected to the monitoring port in 2950, the tcp reset feature don't work? Does anyone know what's the problem of it? Accept configuring the monitoring port in 2950, any other configuration is needed to make t...

I signed up over a year ago to receive the updates by email when they became available and was receiving them. I have not gotten the last 5 updates. Has anyone else not been getting the IDS updates?

Hi all,I have configured two PIX515E with 6.2(2) OS for failover operation. The two devices are connected with the failover cable and they seem to work properly. If I configure on the primary active FW the lan-based failover, I get the following mess...

Hi: Is it possible to connect a 515e with DMZ to two service providers? One in the outside interface and the other in the DMZ interface? If it were a router I could enable a dynamic routing protocol and talk to service providers to do the same, but i...

Hello,We've been trying to fix some fragmentation issues with our VPN clients. I have GRE Tunnels Setup. I've set the MTU on the Tunnel Interface to 1420, the MTU on the Tunnel Source FastEthernet Interface is not set.When displaying the Tunnel Inter...

Does the 3002 support multicast functionality?

how secure is frame-relay infrastructure from attacks. Cant find any such documentations.

Had these files fill up the /var/ partition they were in /var/tmp/ on a few differernt netrangers they contain nothing but ip address with port 80 and the ip's can't be found in the netranger logs.

Hello,Syslog logging.If I log warning then the reports generated through webtrends are not detailed enough.If I log one level up which is informational then the log file sits at aroung 3.6 gig a month.Will the pix ever have the log functionality at t...

Hi,I'm not able to disconnect the adsl line from a 501 pix.The commandclear vpdn [group|interface|tunnel|username]does not go.Can you help me ?Thanks

We have a full class C subnet on the PIX outside interface, part of this range is being used for static NAT for various www servers. Our intranet servers are accessed using the ouside NAT'd IP address rather than the real IP and we're having problems...

My platform is a Cisco 2610. The IOS image is "c2600-i-mz.122-2.T.bin. Need to configure CBAC. The Feature Navigator Tool lists both the IOS Firewall Feature Set and CBAC as supported by my platform running the above ios version. However, when I iss...

all,i'm looking to build an access-list to monitor the web traffic of one particular ip address and to log the results to the router. does anyone have an example of an access-list that will perform the actions listed above?thanks

Below is a sample of KaZaA alarms detected by my IDS that is onthe inside of our firewall. My IDS on the outside of the firewallis not detecting the traffic. That makes sense, since udp 1214 isblocked at the firewall. The KaZaA user is 132.170.x.y. T...