Hello All,I used IDM to create some filters on a number of signature. I works great to filter out false positive alarms. How do I populate these filters to my CSPM? Any help will greatly be appreciated.Thanks,Damien Dinh
Is it possible to set multiple levels of trap logging on a PIX 515? I have a syslog server that I want to receive informational level traps, but want my Openview server to only receive error level traps.Thanks,Doug Davidson
Trying to run vpn3002 in network extension mode. tunnel initiates but ip traffic does not seem to return. I have tried several static routes on the PIX. What is the correct static route for the private network on the vpn3002? Network works if PAT...
I'm using a 7204 as my edge router. this has IOS version 12.1 with the firewall feature set; I'm also doing NAT for the webservers; I want the internal users to go to the internal webserver; the A record for the webserver is a public ip address, the...
I want to allow all my internal clients the ability to successfully ping anything out on the internet.I understand the access-list / access-group needed for this. Here is what I have...access-list 101 permit icmp any host 200.1.1.5 echo-replyaccess-...
Hi everybody!I´m trying to improve the control and the access to the routers in the company, there is a group of users that need access to the routers and I want they do not be able to perform commands like: config terminal, reset, clear, reload etc....
In the notes for the new S31 release it says that signature 3050 (Half-Open SYN) has been tuned, but it does not say in what way. Can someone give me some insight into this? Thanks.
I'm just wondering, i have two PIX506, and i already have a vpn tunnel between them, is it possible to encapsulate the IPX traffic with a GRE tunnel? if so, what do i need to do on the pix?look forward for any reply. thank yousimon
Hello,i have the following Problem:I have greated an ACL.When I debug this ACL (debug ip packet 101 detail), i see very much Multicast Traffic.This is on a Catalyst 3550 EMI.If i debug the same ACL on a Router, i only see Traffic for this ACL.What sh...
Is it possible to set multiple levels of trap logging on a PIX 515? I have a syslog server that I want to receive informational level traps, but want my Openview server to only receive error level traps.Thanks,Doug Davidson
I have a Cisco 1720 Router that needs to run IP/FW/IPSEC 56 software and in addition support both ADSL-WIC and WIC-1B-S/T cards. The ADSL service will be the primary route whilst the ISDN will form the secondary route.Is there an IOS version that wi...
A very basic question.Iam new to cisco IOS. we are having a cisco2509 with 12.1T IOS.I would like to know the command for deleting a entry in the access-list.Thanks,
