trying to upgrede mars 6.0.1 to 6.0.4 but it's faailing,here is the command I put when i ssh to the appliance with the Ip address (pnupgrade cdrom://package/csmars-6.0.2.3102.zip) so is there anything wrong there.
Hi,I am new to CSA and have been trying to figure out how to block the Windows cmd.exe process outright? Is anyoneableto assist or point me in the right directionthanks?
hi,Newbie question here. how can i add a vlan to a fwsm module. What are the steps i should do? And also, can i directly assign the vlan i add to fwsm directly to a switchport (i.e. access switch)thanks.
Hi, Good day to all NetPros. I would like to ask something, and answers are greatly appreciated. Our company is running Pix515E software version 6.3(3). Our mother company did a network security audit, and found out that the appliance is runn...
Hi,Does anyone know if their are any issues with running CSA 5.1 MC and CSA 6.0 MC on the same Windows 2003 server? Are their any know issues with them writing to the same database?I will have to upgrade the Server 200 OS to SP2 so I am hoping that t...
I need to add a third stackable 3750G switch to an existing stack of 2 and was wondering if the first 2 need to be powered down before I install the third?Do I need to configure the new switch with anything specifically? (aside from assigning ports, ...
HiI received this error message when I try connect to my router ( Version 12.2(17r)S4). I regenerated the RSA keys at 2048 bit instead of the 1024 but the message still appears. 5 15:59:19.345 CEST: SSH2 0: Unexpected mesg type received5 15:57:26.37...
I'm in health care and deal with several FDA vendors and their devices(PCs). These PCs run medical apps or attached/control other devices like radiology, EKG, bed monitoring..etc.Since these devices are FDA approved, they can't be patched at all(MS u...
Hi,I have a firewall ASA5520 that has a CSC SSM20 module in it.The module as the last OS (CSC SSM 6.3.1172.0), and the firewall as the OS 8.0(4).The CSC SSM20 module, and the firewall, is configured like Cisco advice for this case.The thing is like t...
Hello,I have written several custom parsers, all of which extract source/dest IP and port from raw messages. They're all working fine in that respect.What I need is for the MARS to also parse out the "protocol" value, which isn't present in the messa...
Hi All, I am going to setup NAS as real IP gateway, L3 and OOB. Can I setup both NAM and NAS (trusted interface) on the same subnet? I heard from some folks that NAM and NAS must be on the different subets. thanks for any suggestion Alex
