HiI want to purchase 2 ASA5510 (ASA5510-SEC-BUN-K9). One device will act as failover for the other. Am I able to buy the second device any cheaper and if so what is the product code?ThanksGav
I'm trying to add A CAS server but I'm getting the error above.The error log shows "Maximum limit for Clean Access Servers supported has been reached" but I have no CAS server defined.
We have a large corporate VPN solution that using DHCP forces DNS / Wins server to each VPN client once a user establishes a session. Temporary during a small migration I need to set specific DNS & wins servers. Is there a way from the VPN server to...
Has anybody configured this and got it working with the new 4.0.0 version?If so, can you provide some steps and any tricks to get it working. I have run ktpass on my AD controller and the SSO service is running on the CAS and I have the Auth Server ...
Anybody tell me detailled procedure of IOS upgradation and downgradation at firewall & can I upgrade the IOS through Xmodem. Also I read the book for that but I am unable getting any single thing from the book. Anyone can describe me it?
My understanding is that any firewall needs to monitor the FTP control port to know which dynamic ports to open.Since in secure ftp control port is also encrypted the firewall cannot monitor the control port so it is not possible to access a secure f...
I am having an issue with my remote sites using 1811 routers. With the "Detect noncompliant HTTP traffic" option checked under application security, they are unable to go to yahoo.com and I see the Sig:15 Protocol violation when they attempt. Any s...
Dear All,Good Day,I have two firewall stages. First stage includes two Cisco PIX 525 configured as failover A/S. Second stage includes two symantec gateway security 5440 configured as Load-Balancing. Actually,my ISP did not give me enough public IP's...
I have a c1841 where i used as hub router to several spokes some connected using ipsec tunnel & others using frame relay, i am facing a problem in spoke to spoke communication, although the tunnel & frame relay are all ok & hub to spoke communication...
HIcan we use ASA5500 (HA mode)device as border device (inplace of router?). Does it has capability to run routing protocol like BGP? So that it can make peering with ISP links for redundency?thanksregardsRakesh======
I just need someone to review my config and make sure Im not crazy here. access-list nonat permit ip 10.1.0.0 255.255.0.0 192.168.0.0 255.255.255.0 access-list nonat permit ip 10.3.0.0 255.255.0.0 192.168.0.0 255.255.255.0 access-list nonat permit i...
In IPSEC there is concept called SPD(security policy database) and SAD(SA database). What is the difference between them? what command can I use to see the output for them? Thanks
I recently worked out a basic configuration to provide a 3 interface firewalling scheme. Inside, outside, and dmz, on the subnets. 10.200.251.0, 10.200.252.0, and 10.200.253.0 with mask 255.255.255.0. After realizing that I need to upgrade versio...
