Hi,I have some ipsec tunnels set up between cisco routers. When I do a show interface them I get this: Tunnel transmit bandwidth 8000 (kbps) Tunnel receive bandwidth 8000 (kbps)How does this get set, and can I change it?thanks
I created a rule that logs whenever changes are made to any registry key.After a day, I'm looking at what was triggered and for the most part its doing exactly what I wanted it do. But I'm thinking I want to get more specific with this rule to cut o...
Hi:i have a pix firewall, which is conneted to DMZ, outside and inside and i have also a web server which used as public service for the outside users (any client) my points if i put this server in the LAN instead of dmz by using static nat what secu...
Hi,I have a pix with the following outside interface:ip address outside 192.168.0.179 255.255.255.0In the pix i found a default gw like:route outside 0.0.0.0 0.0.0.0 0.0.0.1 1I do not understand what the default gw 0.0.0.1 means? Shouldn't this be a ...
Well I am trying to find out whats the best option when it comes to IOS upgrade. Audit is telling us that we have to ssh into all of our routers and it should be nothing less than version 2. Now since almost all of our routers are on 12.1 build, I ...
When an entire ACL is blown out and applied again on a PIX 6.3 should we need to apply it again to the specific interface or it will be applied by default to the specific int???
Hello,Is it possible to translate ip address of a dmz interface on PIX 6.3.5?I have put the static configuration and have put acl to permit icmp any any but the host on the outside cannot ping the NATed dmz interface address.
Hello, Netpros. I have Cisco VPN 3005 Concentrator with IOS 4.7 running. I wan to configure Rules under traffic management, as i wan to allow only 4 to 5 ip addresses and wans to deny rest of all the ip address. How to define that under Network List....
I need to have multiple ip addresses on a FWSM interface that is presented to the vlan. Is this a possible and if yes how can I accomplish this. Thank youD
I currently have a Cisco ASA 5510 that I am allowing pptp connections from MS vpn clients to our MS remote access server that is behind the ASA. It seems that only 5 users at at time can connect to the network from the Internet through the ASA. Wha...
Greetings.I'm using a 3620 running 12.3.16a IP-FW-IDS 3DES code as a IPSec server for a single client, not site to site. The conneciton uses 10 dot addresses inside of a NAT. It uses a pool for the moment likeip local pool ipsec-51 10.200.51.100 10.2...
The CNS Documentation suggested that " Do not create a Windows domain that equates to a DNS zone (such as example.com). Instead, create a subdomain, such as local.w2k.example.com " in the following page http://www.cisco.com/en/US/products/sw/netmgtsw...
