Other Security Subjects

Hi there. I'm trying to configure an ASA5510 with no luck.My network is very simple. Computers on the inside with a single router connected to the internet. Use NAT to protect inside addresses and allows access to cetain machines with static addresse...

I'm a new user and can't quite figure out how Mars "sees" things; e.g., worm attacks, strings in packets, etc.It is not a gateway thru which all traffic passes ... it just sits there and looks at devices and therefore cannot examine packets.Does it,...

I'm wondering does the Cisco Secure Desktop come bundled with the ASA5510?I can see config examples of the ASA pushing out CSD from it's flash but haven't seen it clearly stated if CSD is an extra-cost over the ASAthanks

dears, can i Add secondary ip address to 506 firewall interface to support two different network

Hi everybody,I’ve a few questions about firewall (ASA) designing. Attached is my connection diagram.1. Can I use L3 switch as default gateway for PC and add 2 default static routes to both firewalls on it? Does it have any problem about route back pa...

HelloI have a 1841 integrated router as my firewall and I have pptp and gre ports open on my outbound traffic. But when I try to connect to a remote site using Windows Remote Desktop the session hangs before the login prompt. I permit any on both the...

Hello, I was just wondering if the CompTia Securty+ Certififcation is a good fundation for the CCSP?Thanks

Hi,So I tried copying the silent install file for cta 2.0 into the cta directory of the csamc. I was able to make a kit and install successfully. However, when looking at host detail, it says: Cisco Trust Agent Installed: No. Any ideas? Thanks!

I have some problem. I configured several snmp commands on router with IOS 12.3(5d). I tried it on CISCO 1701 and Cisco 2621XM. These are the commands:snmp-server community test1 RO 10snmp-server community test2 RW 11access-list 10 permit 10.10.10.10...

We remote site connected with IPsecwhen we ping to remote site router inside interface we have latency around 20ms when we ping from remto site to central site (at same time) we have 350 - 500 ms and some timeouts... I wonder how its possible if its ...

Hi. I must be mising something simple. This access-list/access-group combination worked with PIX 6.X code and the PIX 7.X code, but it won't work with the ASA 7.X code. It's a pretty simple access-list:access-list outside-acl extended permit icmp ...

We are having issues going through the ASA 5540(7.11)to the internet. It is very slow. Ports are all configured right. This is a non production network. On our production network we have an FWM and we are having no issue there.

Hey all, I am looking for any body that can give me a very good recommendation on any books to prepare you for all of the CCSP exams.Also any websites as well.Thanks

All,Is there a capture tool, similar to the Pix has, for routers? I am trying to access a router via ssh, but I can't. I want to run a "capture" on the external interface to see if the packets are reaching the router or not and/or being NATed along t...