Other Security Subjects

Not sure this is the right place to post but I have a client whos having issues with Checkpoint secure remote over IOS based firewall. It does connect but seems to timeout. I'm using dynamic NAT so I dont this its a NAT timeout issue. Anyone got e...

Where can I find an example of basic firewall config with NAT for PIX 515 (v.7.0) where the external IP address is obtained from a DHCP server?Thank you!

Will the DMVPN tunnel at the spoke end use and load balance encrypted traffic if I have multiple T1's starting on the same router and teminating both circuits on the same router at the other end?Thanks,

I wanted to use a VLAN with an IP-Adress at the MSFC2 as a transfer VLAN for the FWSM.The MSFC should route to the outside. The FWSM is in a Multi-Context, routing Mode and there should only be one Transfer-vlan.The Cat6500 has CatOs and the MSFC IOS...

Hi all,I am having problems using Outlook Web Access 2000 through a WebVPN session on a Cisco VPN 3005. Once I have connected via WebVPN to the concentrator, I click on the link to my OWA server and get the correct opening page (as I would if not usi...

Hi all,i've found a strange problem with equinux vpn software and new 1841 adsl router.When i use the old 837 adsl router the software works fine and vpn goes up and running. If i change the 837 with 1841 ( with on board 2 wic-adsl + ppp multilink ) ...

When I connect to my PIX 501 (6.3(4)) from outside I authenticate and can ping the internal machines OK. But I can't map any shares on those machines.When I try to map a drive, I see the following in the PIX log:No translation group found for tcp sr...

I got a lot of error message from my syslog server , I check FWSM system message got explanation "catch-all error" anyone can tell me what's catch-all error ? What reson production ???Feb 10 10:37:51 172.19.239.243 %FWSM-6-302014: Teardown TCP connec...

Hi,We recently migrated Server VLAN behind FWSM running in transparent mode.Before migration, access to mail server was working fine. All users accessing the email server are required to login.However, after this VLAN migrated behind FWSM, users are ...

HiWe've got a BBSM 5.3 SP2, to which we can't get RDP/TS access for management - is this normal?From the box itself we've noted that you can RDP to itself on it's external interface, but not to the Internal interface.We've tried changing the binding ...

Hi,We have a scenario where a pair of PIXes exist, connecting two seperate entities, with outside interfaces on the same subnet.We replaced one of the PIX firewalls with an ASA and had everything configured correctly, but communications between two e...

Welcome to the Cisco Networking Professionals Ask the Expert conversation. This is an opportunity to discuss with Cisco expert Charlie Stokes about Intrusion Prevention Systems. Charlie works as an Intrusion Prevention Systems (IPS) technical marketi...

Hi,I have been tasked with redesigning our DMZ environment. Presently we have Pix 515e's in f/o bundle, which has inside, outside, and dmz interfaces.Due to security requirements we now have a need to create a multi-layer firewall architecture (2 ASA...

ASDM has been working fine, but has now decided to stop working. When I try to start it, it now goes into a loop showing 'Parsing Running Configuration', followed by 'Verifying Running Configuration', then back to the beginning again.Any ideas?ASDM 5...