Other Security Subjects

Hi All,I installed SSL certificate on my VPN concentrator by following the steps provided in a document. After installing the certificate, I am accessing the concentrator using https://<ip-address> and I get a login prompt. But when I enter username ...

I have 2 ASAs in transparent mode, with multiple contexts, active/active config. I do not want to load balance. Do I need to define that in the system exec space?Also, I want to enable telnet to both ASAs. I've configured an IP to the primary ASA's a...

Hi,I use 2 Pix in failover Active/standby mode ver 7.0(2). I've start to enable ipv6 on the first interface but I can't add a standby address like for ipv4. I've try to configure ipv6 address without standby address and I've found duplicate address o...

We have a user in our domain with every USB device you could think of connect to his PC.The CSA is creating this error message about 60 - 100 times a day The intelligent agent denied this request due to a timeout. If this message happens frequently, ...

Hi!We have configured a FWSM for authenticating via https, e.g. aaa authentication secure-http-clientWe are authenticating against a RADIUS server and everything is working.However our company security policy advises to not make use of self-signed ...

Hi, using an ACL with NAT exemption, I'd like to have the following:Traffic from 10.10.10.0 /24 bypass NAT exemption and allowed to be NATdAny other 10.10.0.0 /16 traffic, don't NAT it.My thoughts are this can be done using the following commands:nat...

Hi.I have a QTEK 9000 Pocket PC, running Microsoft Windows Mobile Version 5.0I can connect to my Cisco 3005 unit with WebVPN and the login is succesfull.I can allso browse the internal webservers in the Internet Explorer.What I would like is to make ...

I've my management network of 172.16.0.0/24.i am unable to telnet one of my DMZ-Firewall set. Attached file has the conf info.Please let me know why i am unable to reach this firewall via telnet from my manangemnt network where as i am able to reach ...

Configured webvpn homepage via quick start. After login, banner appears, but links do not. Have enabled file access under Groups and listed links under Servers and URLS. Why don't the links appear on the Homepage?

After passing all the procedure for password recovery, at the last line, when i type tftp and i valid, i can not reach the tftp server.I am using the tftp on windows 2003 server.Could you help ?

Hello,I try to install VPN Client for Linux ver. 4.6.03.0190 on PC with SUSE 9.2, but I receive this message:Cisco Systems VPN Client Version 4.6.03 (0190) Linux InstallerCopyright (C) 1998-2005 Cisco Systems, Inc. All Rights Reserved.By installing t...

Hello,I recently setup a web server and used the DMZ port on the Cisco pix515e.I could not access it from the 192.168 network so with help from cisco I issued these commands:static (dmz,inside) 68.217.84.114 172.18.0.10 netmask 255.255.255.255global ...