Other Security Subjects

No one wants to respond to my "VPN to SOHO97" so let me try this. I am using the following:Cisco VPN client 3.6SOHO 97 routerWindows XPWhen trying to create the VPN my router log keeps showing the following lines and creates the VPN, but will not pa...

I just came across this MS announcement re a DOS vulnerability with RDP. If we have 3389 open for RDP are there any other precautions I can take on my PIX to limit the exposure to this? For instance adding some limitations on the end of my static ...

Why I can't configure the ip and the nameif in the pix?

I'm assisting in the overhaul of a network. They're moving from Netware to Microsoft. Part of the existing Netware network is a BorderManager server that will be replaced with a PIX 515E.The BorderManger server is currently the 'default gateway' (1...

How does PIX check Websense server status? Does the firewall merely check if it can reach the server? How about Websense database check?Thanks,Jim

We have a Branch office pix 501 with a working VPN pipe to a Concentrator in our Central office. We want to direct all external traffic in the Branch to go out by VPN to the Central office network. How do you force the branch office LAN to use the VP...

Hi Pros,lets do it short:pix as nas for pptp with mppe (windows XP) working as a radius client to w2003 IAS worked fine.After change to 2821 ios mppe was no longer possible: "mppe not negotiated"...read a lot of threads on the same problem, spent a c...

Is it possible to use a dual hub DMVPN solution when the 2 hubs are not located in the same subnet ?When we use the configuration examples in this document http://www.cisco.com/en/US/tech/tk583/tk372/technologies_white_paper09186a008018983e.shtml#dua...

pix 501Microsoft ISA 2004I have site to site vps tunnels in place from Isa to cisco 501's. I what to setup the pix's to froward all internet traffic to Isa server so that users from remote site have to go thru Isa server for internet access. What do ...

I have an FWSM (software version 2.3(2)) installed in a Catalyst 6509 (Supervisor 2, MSFC2, PFC2). NAT Exemption is enabled for all addresses and there are only two rules - permit all incoming and permit all outgoing. All routing is by OSPF. When I m...

im trying to understand how this worksi have a PIX with 2 interfacesthere is an access list applied to both interfaces and the associated access-groupthere is also another access list which is set to 'ip any any' and it is attached to a nat 0 stateme...

-----Problem-----The 'Management Center for Cisco Security Agents' database is approaching its maximum allowable size (2GB). Please purge old data. -----Action Taken-----I used the "Event Set" tools to delete "All Events", but it doesn't make this er...

in the case below we want to java applets to be downloaded from 150.50.4.80. The INFILTER allows just about everything in. TCP, UDP, and HTTP-Java are allowed out. Now access-list 1 permits a *source* of 150.50.4.80 yet the outbound inspection should...

When doing remote access VPN. The ip pool is defined as 192.168.0.0 - 192.168.0.10 After initiating the session the client receives 192.168.0.0 and assigned.Communication is happening.Any valid reasons.

I have a PIX 515E and I can't use the nameif and ip commands. I'm with version 7.0(1) and device mangaer 5.0(1)Thanks,