I am running a 515E firewall using S/W 6.2(1)We are managing a network on the inside of the F/W that is 10.0.0.0/8.On the outside we have a number of statics -static (inside,outside) tcp 203.42.151.10 ssh 10.17.100.10 ssh netmask 255.255.255.255 0 0 ...
using standalone (N)IDS what are the options (pros-cons) for the connectivity design. All 10/100 switched environment for this application. portspans,VACL's,TAP's or specialized active IDS balancer's. A broad question, but I am looking for some input...
I would like to filter activex traffic to any other site except for 207.46.0.0/16. If I enable filter activex either I will filter all or only filter specific site define on access list. Is there any way to allow this segment 207.46.0.0/16 and block ...
Dear list, When I run SigWizMenu on our sensors I receive “Unconsumed token(s) [Attempt to parse Non-Numeric value.] passed to parameter "ServicePorts"What does this mean?The sensor currently has the following version installed.>nrversApplication Ver...
Can someone tell me a quick and dirty way to block ports on the above mentioned layout? I am trying to avoid access lists if at all possible, because I do not have the time now to fully hash out all needed ports. Basically, I need to be able to blo...
I have a PIX 515 at my main office and several 505s at remote offices. All the remote offices connect to the central office through split tunnels I setup with the VPN wizard on PDM. What do I need to do to make these full tunnels? Help with some co...
in fwsm 1.1.2 the static command of pix6.0 is included.does anybody know, if the implementation of the static command of pix6.2 or pix6.3 on the roadmap of the fwsm?is there a document where the roadmap of the fwsm is described?
I have 3005 concentrator at central site and 3002 hardware client at remote site. I using 172.1.1.1/16 at the concentrator private interface and 10.1.1.1/24 at the hardware client private interface side. Enabling network extension mode .Tunnel is up ...
The vpn 3000 concentrator, has the ip address public 200.X.X.1 and the ip address private is 10.1.1.1.in this moment any person access via browser and telnet at the equipment.As deny the access of this ip addres via browser and telnet?Thanks
I have followed instructions. chmod +x IDS-sig-3.1-3-S49.bin./IDS-sig-3.1-3-S49.bin -IAt this point I expect somthing to happen - but nothing does. Am I missing a step - I even di an Init 6 to be sure - but it still shows as S44
We have multiple sites. In some locations, we have a PIX515 behind a 1720 Router. In others, we have only a 1721 with the Firewall Software Set installed (c1700-k9o3sy7-mz.122-11). All equipment was installed and configured by a channel partner wi...
