Other Security Subjects

Announcement #64 at http://www.cisco.com/en/US/netsol/ns110/ns170/ns171/ns292/networking_solutions_newsletter09186a0080136734.htmlsays that the S48 update will NOT work with the NRS-xxx sensors. But the README for the S48 update sez that it WILL. W...

Hi there,Seen this artical http://www.eweek.com/article2/0,3959,1197510,00.aspWill this Signature that we have on the IDS be able to pick up this attack?We can I read more about what specific signatures will pick up?Thanks Mike

Hello,Just curious if there is some link to all of the modifications made to 6.3.1 to get the new version just released 6.3.2?ThanksJeff

I have 64MB RAM and 16MB Flash. I am trying to load a config file that's 641KB. Is there a way around the 32KB limitation for config file?

Is the version of What's Up Gold that comes with CiscoWorks version 6.1 the same as the Stand Alone What's Up Gold version 8.1

Hello, We have a freshly installed cisco IDS censor and we are using policy manager to gather logs, can the IDS be cofigured in a way that it automatically updates it self whenever a new patch comes put. Also, a new cisco vunerability came o...

hi,when i try to update my IDS sensor's version thru the ciscoworks IDS MC, It always have a pending configuration created... It does not update the sensor actually. the next time i login, it will show the old version again.. how can i solve this pro...

Anyne have any suggestions on my problem. We have a PIX 515E that seperate the DMZ and Intranet. But the Web Server have a slow respons when send a request to inside database server. If we move the database server to DMZ . then is OK.

Dear AllI recently implement IOS IDS on CISO 7204,i have three 2 Mbps links terminated to my serials.Problem i am facing is that when i implement IDS my router CPU load goes so high up 99% and then it stops working.I implement the IDS on all serials ...

This morning I had an issue where none of my end users or servers where unable to pass from the inside to the outside of my PIX 520 firewall. I have a NAT & PAT configured on the firewall. When I show xlate I only saw two servers that had translation...

Is it possible to configure internal interface (on which is the NAT inside command) to pass the traffic from the inside other than that was defined for translation? I mean, if I have NAT and a pool of addresses bound to ACL which permits internal use...

Wondering if anyone has info on the impact of applying an ACL to 130 subinterfaces on a 7206 router? Have anyone done this before? Any significant performance problem? Each interface is a FR Pt-Pt. I'm applying the ACL per Cisco Security Advisory.

HiI have the usual error with pasive ftp and Invalid Port.I however struggle to make it work with my other config.ip nat inside source static 31.yy.yy.248 1xx.xx.xx.99 extendableinterface Serial0.500 point-to-point ip address 1xx.xxx.xxx.97 255.255.2...

Hello,In IDS Device Manager 4.02S47 --> Configuration --> Sensing Engine --> Event Filters : if I put one IP address in "SourceAddrs", the filter is OK . But if I put 2 or more IP or a subnet address, I have no error message but I continue to see log...