Other Security Subjects

Hi all,I have to backup the vsm system, the problem is that the license is expired. was the 90 days lic. we have full license but we never requested the files for that.I 'm reinstalling on a new pc,.Now is it possible to backup the database with all...

I need to turn off DNS Gaurd to test a theory about reverse lookups not succeeding by outside mail servers. It has been brought to my attention by users that certain mail servers from other companies will perform a Reverse Lookup on the address send...

I have a server in the internal LAN with application that only talk to the internal address. Is there a way that I can nat the vpnclient address to the internal address that the vpnclient can use the application?Eppie

Has anyone used a modem and telephone line with the IDS-4210 for out-of-band management?Are there any special considerations? The IDS-4210 has a serial port in the rear and one more in the front. What is the serial port in the front? Can I use it to ...

I have three problems about FWSM when I deployed it .1. I can't use the FWSM interface ip as the gateway for the PC to route traffic to subnets through routers which is on the same network as the PC.2. When I ping hosts on higher security level from ...

Dear Techs,I'm implementing Network-Based IPSec VPN Solution for a Service Providers. By using the following platform 7200/NPE/G1 with VAM2 card.I would like to know the following:If their is a MIB for the VAM2 card?How to manage the IPSEC session (g...

I need to limit access from the DMZ to a resticted list of IPs/Ports on the inside n/w, but the DMZ machines must also be able to connect to the Internet (i.e. unknown IPs). (I have disabled NAT between DMZ and Inside)If I apply an access list to the...

Hi,Can anyone tell me how to enable http access for a certain host on the outside interface (internet) on a Cisco 3000 Concentrator? I have created a management workstation but it still does not seem to work.Any ideas..Rgds,LR

Hi,I looked this alarm up on Cisco's Secure encyclopedia http://www.cisco.com/cgi-bin/front.x/csec/idsAllList.pl for this errorm message but I couldn't find any information on it. Does anyone know what this 997 alarm means?High Severity Alarms An...

Hi,My sensor is only reporting Route Down and Route up as well in PostOffice messages. All the other alarms are not showing, not low, medium or high. I checked connectivity with the CSPM 2.3.3i and the sensor 4210 running 3.1(3)S46.Any ideas??Thank...

I have configured a 1760 as an EVPN server with clients succesfully connecting using unified client version 4.x. now trying to configure it to connect to a PIX 501 running in Network extention mode. Having problems with extended authentication, using...

Does anyone know a quick and easy way to do this without using access lists? I am using IOS 12.x and would like to block the ports associated with the WIndows Messenger Service from coming into my company network. Thanks!

When entering the commands to open the proper ports for PPTP VPN (1723 & 47/GRE) through the PDM on my pix 506E the gre defaults to a different IP address with a /30 attached to it. Could this be the reason why I cannot tunnel in from remote sites? ...

I while back I asked if you could block directly from the sensor in version 4 without VMS or CSPM - and was told you cannot - however further reading leads me to beleive that you can block without a separate management console - can anyone verify th...

Dear all,Can anybody tell me whether there is any bonus to using a NAT'd address over a valid outside address ? - other than to save on registered outside addresses.I was wondering if there are any obviuos security risks in letting single workstation...