Other Security Subjects

I while back I asked if you could block directly from the sensor in version 4 without VMS or CSPM - and was told you cannot - however further reading leads me to beleive that you can block without a separate management console - can anyone verify th...

Dear all,Can anybody tell me whether there is any bonus to using a NAT'd address over a valid outside address ? - other than to save on registered outside addresses.I was wondering if there are any obviuos security risks in letting single workstation...

Dear AllI am new to this IOS IDS think first ofi want to know some document whcih can tell me details about IOS IDS features and implementation.Secondly,What is the differene between ip audit info and attack signature and why these both cannot be use...

Helo.I have a Cisco 1720 wifh 2 ADSL WIC. I need to balance the trafic from my LAN through my 2 ADSL Lines.Anybody can help me?Thanks

hi alli m a beginner on SSH,i hve configured SSH in one of our router(3640).As explained in the cisco site i created the domain name,hostname,crypto key generate,authentication timeouts,retries.After doing all these i binded the same to the line vty ...

What is purpose of skip in ids and its importance

I am installing a PIX 515 with a failover box. Both units are connected via the failover cable. The problem I am having is that the primary unit is showing that it does not have Failover enabled. When I try to enable it, I am being told I do not h...

I am new to cisco ids. our company already has an IDS blade in the cat 6509 switch. We also have pix but there I was told that PIX is Vulnerable to the following attacks: UDP Flood IP Range Scan DoS/DDoS HTTP attacks spanning multiple attacks 1. Can ...

I have to move our Pix525, resulting in a long distance between the outside interface, which is a pix-1-GE-66, and our ISP. The interface is now connected with a multimode-connection to the ISP-router, but in the new situation I will have to use a si...

Hello,My questions are related to the IPLOGs (raw packet payload data). I'm planning to setup IPLOG for high/medium events only because they're the ones we usually need to look into the raw data.1. When a high/medium event is triggered, it would gene...

Hello,I am looking for a document/link for setting up security on an internet router. What Access lists should be implemented; services denied both inbound and outbound. A common practice type document would be great. In particular, what are the ra...

I need to confiure Ssh on our switches with catOS. Reading up on it I guess you have to do an IP permit list. Is this IP permit list mandatory or optional. I basically just need SSH and need to be able to get to the switches from all our subnets.Than...

what can I do on the router if I want to hide the traceroute

HiI do not completely understand the functionalityu of the command "sysopt route dnat" on the PIX.Could someone explain this for me please!!!