07-25-2007 06:31 AM - edited 02-21-2020 03:10 PM
I can ping PC's over our remote VPN (concentrator to a remote Pix) but not the Pix that is over at the remote site. I am trying it's local IP address over the VPN.
However the PC's on the Pix's LAN can.
I can get on the ADSM using the Pix external IP, but I'd rather use the internal IP over the VPn tunnel.
Let me know what info you need.
07-25-2007 07:35 AM
Weird, this is what I get...
Result of the command: "config t"
The command has been sent to the device
Result of the command: "management-access inside"
The command has been sent to the device
07-25-2007 07:29 AM
It could be blocked. If you already have management-access inside enabled, rules could be the cause of the problem. Otherwise it is unlikely.
07-25-2007 07:36 AM
Found it...
Config -> Device Administration -> Management Access -> Select inside
07-25-2007 07:39 AM
Right I have selected the inside interface, but still no joy on connecting to the local IP. A remote user in that same subnet as the Pix can though.
07-25-2007 07:43 AM
What PIX version do you have?
07-25-2007 07:46 AM
7.1(2)
Would the fact that I don't have a service policy rule be a problem too with this?
07-25-2007 08:01 AM
It should not be a problem, this is a global command.
Can you execute "show management-access" in config mode?
07-27-2007 05:02 AM
I can now ping it's internal address over the VPN, but can't accesses it via the ADSM, any ideas?
management-access shows local_network
Thanks
07-27-2007 05:17 AM
you need to add
http
07-27-2007 05:38 AM
Still no luck, I put this in:
http 192.168.9.9 255.255.255.255 VPN
VPN is our tunnel to my office
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: