cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
298
Views
0
Helpful
1
Replies

Cisco 837 - No PDM web console anymore

whiteford
Beginner
Beginner

We have put our own configuration on our Cisco 837 router. We are using a quite recent IOS and before we put our configure on the router we could get on the web console, but now we can't. hav we removed some important settings? I have enable IP http server and IP http secure-server and it load a rubbish website with the following displayed:

Show diagnostic log - display the diagnostic log.

Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15

Show tech-support - display information commonly needed by tech support.

Extended Ping - Send extended ping commands.

How can I get the PDM back?

1 Reply 1

smalkeric
Frequent Contributor
Frequent Contributor

copying of Image from one PIX to another is concerened. It is not possible until or unlesss you have the PIX configured in the failover mode.

Once you get the access to the Cisco softwares then this time try upgrading the PDM to the latest Version and then check it out.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: