Cisco Catalyst Blade Switch 3020 for HP

[armands_t]

Hi,

Can anyone tell what is the Default username and password for "Cisco Catalyst Blade Switch 3020 for HP"?

After reset to factory default we have LAN connection but we can not log in.

Br, Armands

[Moaz.Elzhrawey]

Hi,

For this model of switches, if it's completely brand new with no configurations on it at all, so the console password is blank, just press enter.

"Quote for Switch Getting Started" document,

The initial configuration assumes that the switch module was never configured, that it is in the same state

as when it was received, and that it is not configured with a default username and password

 but if you have it configured before and you don't have the password, so you should go with Password Recovery Procedures.

*** Please rate this as "Answer" if it solved your problem.***

[armands_t]

Hi,

Thank for answer.

If I understand correctly I do not need username for connecting via Console, is it so?

If not, then what is the username?

Br, Armands

[Moaz.Elzhrawey · Accepted solution]

Yes, you understand it correctly. 

If you pressed enter and you got error login or wrong username, this means that the device already have configured user and pass, so go with password recovery 

[armands_t]

Hi,
Thank you very much.

Br, Armands