cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

125
Views
5
Helpful
2
Replies
Highlighted
Beginner

Cisco Remote VPN question

I currently have 5 sites that are connected via hub/spoke LAN-to-LAN connections with Denver being the primary site. We are looking to enable Remote VPNs using the Cisco VPN client. I have been able to connect to the main denver location, but cannot connect to any of the remote sites via the Remote VPN. I have all of the addresses for the remote sites listed in my split tunneling configuration. All of the firewalls are the ASA series using ASDM 5.2. Can this be done?

Thanks,

Jack

2 REPLIES 2
Advocate

Re: Cisco Remote VPN question

So you want to go over ra vpn to denver then go over l2l tunnels to remote sites? A few things, you must define the traffic as interesting in your crypto acl's for the l2l tunnels and also have to enable the following.

same-security-traffic permit intra-interface

this will allow traffic to enter and exit same interface. (outside in this case)

Advocate

Re: Cisco Remote VPN question

This may help as well, this is for pix but is the same for ASA.

http://cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Please rate if these help.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here