cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
908
Views
0
Helpful
1
Replies

Configuring NAC MANAGER HA - link failure detection

Daniel Stefani
Level 1
Level 1

Hello,

I'm configuring HA in NAC Manager and want to enable "eth0 link failure detection based failover". Is this possible in version 4.1.2.1 ?

Where can i configure this in NAC Manager?

See my configurations for the Primary HA on pic attached.

kind regards,

Daniel Stefani

1 Reply 1

Lauren Sullivan
Level 1
Level 1

Hi Daniel,

It doesn't look like that's an option in the 4.1.2 line.  You can configure this in 4.1.3 line, however - see the configuration guide here: http://www.cisco.com/en/US/docs/security/nac/appliance/configuration_guide/413/cam/m_ha.html#wp1040221

HTH,

Lauren

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: