04-02-2009 05:15 AM
Hi All,
Configuring of NetFlow and Vulnerability Scanning are done.Where and how to check the netflow and Vulnerabilty scanning?
Thanks.
04-08-2009 03:08 PM
After enabling network scanning, you can view individual scan reports from Device Management > Clean Access > Network Scanner > Reports. The report shown here is the full administrator report (Figure 13-13). The report shown to end users contains only the vulnerability results for the enabled plugins. (Users can access their version of the scan report by clicking the Scan Report link in their Logout page.)
for more information follow up on this link:
04-20-2009 07:15 PM
Hi ,
I am talking about CSmars configuration but your answer seems NAC configuration.Would u confirm which is related to CS mars or NAC.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: